DIY Pirate – Steam Punk Necklace
In preparation for Hubby’s pirate themed birthday party, I decided I needed a little accessorizing. Fortunately I have some random crafting supplies (“You? No way”, “Yes, really”) that I threw together to make a bad-ass choker. I happened to find this giant bird pendant at the thrift store attached to a bunch of other beads, and I had this black edging stuff laying around. I bought the black knotted clasp, on the right, for about $2, I think, at the fabric store.
Here’s a close up of the giant medallion/cameo thing.
First, I hemmed one end of the lace stuff, and attached half the clasp. I measured the lacey stuff around my neck, and cut it with at least an inch extra for hemming. This stuff comes apart very easily once cut, so I folded the end in about half an inch, then half an inch again, then sewed it all through to keep it from unraveling.
I put the clasp back together, then measured the lace around my neck again to double check the comfort and the clasp placement. This is also a good way to make sure you don’t have a twist in your necklace. The package recommends sewing the clasp onto your project while it’s together, and that’s good advice to make sure it will line up properly when you’re done.
Test out teh fit again, and make sure it’s snug without being tight. This is also the time to test putting it on and taking it off. I found that it’s easier for me to have the loop part on my right, so my right hand does the more challenging part of closing the necklace. If I had to depend on my left hand, there would have been much pouting and tantrum-ing.
I sewed the camoe onto the choker in the middle to get as much support from the lace as possible. It’s solid metal, and as you can see, pretty large. It works great, and is probably the most comfortable part of my costume. It also took me about 10 minutes to put it together.